CELTO ACOUSTIQUE T2.40

T Series | Touring Amplifiers

Description

Specifications
• Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF) : 2x 2500W 8 ohms | 2x 4000W 4 ohms | 2x 4000W 2 ohms (not recommended)
• Overall gain : 34dB (50 times voltage)
• Sensitivity at 8 ohms : 2.82Vrms (+11dBu)
• Signal to Noise Ratio (A weighted) : 115dB
• Frequency Response (-1dB) : 20~25000Hz
• Typical THD (half power, 1kHz, 8 ohms) : <0.05%
• Typical IMD (1kHz at 4:1, -20dB) : <0.2%
• Crosstalk (1kHz) : >75dB
• Slew Rate : >60V/us
• Input Impedance : 20 kΩ
• Damping factor (1kHz, 8 ohms) : Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management)
• Operating Voltage : 190~250VAC 50-60Hz
• Preamp : Proprietary PureSound Circuit for unmatched sound quality (Audiophile capacitors in signal path, High Voltage Opamps, Ultra Low Noise design), Studio grade TrueRMS VCA limiter, Continuous protection, RF protection, Overload protection
• Power Supply (PSU) : Advanced Switch Mode with 3D-Guard tracking, 105C long life SuperCharged Capacitors
• Output stage : Fully Discrete 4th generation proprietary Class D (93% efficiency at full power), Differential circuit for Load-Independent linear frequency response, Half bridge design with high-Speed high-Current MOSFETs, 105C Long Life capacitors
• Cooling : Front to back airflow Temperature regulated SUNON MagLev fans (50000 Hours, dustproof) FEA optimized Radial heat-sink for maximum heat transfer
• Rear Panel : 2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link, 2 NEUTRIK Speakon NL4, PowerCon 20A (included)
• Speakon Wiring : SPK1 = 1+1- CH A / 2+2- | CH B SPK2 = 1+1- CH B / 2+2- Not Used
• Chassis : 19″ 2U height, 468mm total depth
• Weight Net / Gross : 13kg / 16kg

Reviews

There are no reviews yet.

Be the first to review “CELTO ACOUSTIQUE T2.40”

Your email address will not be published. Required fields are marked *